https://www.sweetwater.com/store/detail/PVi8500--peavey-pvi-8500-8-channel-400w-powered-mixer
Wednesday, August 28, 2024
Tuesday, August 27, 2024
PV®i 8500 400-Watt, 8-Channel Mixer Amplifier WITH SD CARD / USB MP3 /Bluetooth® PLAYER
https://assets.peavey.com//literature/manuals/118110_26340.pdf
https://www.youtube.com/watch?v=S6sFp9X27JQ
PV®i 8500 400-Watt, 8-Channel Mixer Amplifier WITH SD CARD / USB MP3 /Bluetooth® PLAYER
You can use the speaker outputs on the back of the mixer for the NONPOWERED speakers (4 ohm min.)
On the front of the mixer, MONITOR TO EXT AMP or MAIN MIX TO EXT AMP to powered speakers.
Features:
• FLS Feedback Locating System
• Mid-Morph EQ
• Kosmos-C
• On-board 24- bit digital effects with mute button
• Digital effects parameter control
• Combination XLR and 1/4” input jacks
• Selectable 9-Band Graphic EQ with FLS
• Master Mute for channels 1-7
• Footswitchable effects defeat
• 48 Volt Phantom Power
• RCA, 1/8” Media input
• Selectable Main or Monitor dual power section
• RCA Record outputs
• LED Meter bridge
• Power amp sub-sonic filtering
• Clip light and signal present indicator
• Main line level 1/4” output
• DDT™ Speaker protection circuit
• SD card & USB MP3 player
• Bluetooth® player
VENTILATION: For proper ventilation, allow 6” (15.5 cm) clearance on all sides
HIGH EQ
This High EQ shelving type of active tone control varies the treble
frequencies (+/- 15 dB at 12 kHz) and is designed to remove noise or
add brilliance to the signal, depending on the quality of the source.
MID MORPH® EQ
Where most mid-range controls work at just one frequency, the
Mid-Morph works at two. When turned counterclockwise, it cuts at
250 Hz to reduce frequencies that muddy the sound. When turned
clockwise, it boosts at 4 kHz to add intelligibility to vocals. Either
way, improved vocal or instrument definition can be achieved.
LOW EQ
A shelving type of EQ that varies the bass frequency levels (+/- 15 dB
at 80 Hz). Low EQ adds depth to thin-sounding signals or cleans up
the muddy ones. As with any EQ, use sparingly. Too much of this EQ
can give you a booming bottom end.
MONITOR SEND
The monitor send adjusts the level of the channel signal added to
the monitor send. Keep in mind the monitor send can be assigned
to one of two power amplifiers and power an external monitor
speaker.
EFX - DIGITA L EFFECTS
This control adjusts the level of the channel signal added to the
effects mix. The signal is sent to the internal effects processor.
Turning the knob to the left (0) will turn off effects on the associated
channel, while turning the knob to the right will increase the
amount of the selected effect.
LEVEL
This control sets the signal level sent to the main mix.
CLIP
When this LED turns or blinks red, it is an indication that the
signal coming into the channel is too strong, potentially causing
distortion. Turn down the Level control (6) until the Clip light is no
longer present. If you are having difficulty getting a clean signal, try
varying the output of the connected device.
SIG
When this LED is green, it is an indication the mixer is receiving
signal at the input of the channel. If you are having trouble
getting sound out of the mixer and this LED is not on, check the
microphone, instrument or cable that is connected to the channel.
MIC/LINE INPUT
This combination input jack can accept either a 1/4” (balanced or
unbalanced) input or an XLR balanced, low-impedance connection.
The tip is positive on the 1/4” balanced input, and pin 2 is positive
on the XLR.
MIC/HI Z INPUT
Channel 7 line input is a Hi-Z unbalanced input for use with high
impedance microphones, acoustic/electric guitars or other high
impedance sources equipped with a 1/4" plug (TS).
Peavey PVi 8500 8-channel Powered Mixer at a Glance:
- Built-in feedback protection for better performance on smaller stages
- Footswitchable effects and master mute for more control over your sound
- Patented Kosmos-C audio enhancement
If you're looking at an eight-channel powered mixer like the Peavey PVi 8500, chances are you're playing smaller venues and the small stages that come with them. And that would normally guarantee you're going to have feedback issues due to the close proximity of mics and speakers - unless you've got the Feedback Locating System in the PVi 8500. If feedback occurs, the FLS system will light up an LED on the Graphic EQ slider that you need to adjust. Get it dialed in during sound check, and you'll virtually guarantee a feedback-free performance.
Footswitchable effects for more control over your soundIf you're both mixing and performing, you'll appreciate the PVi 8500's footswitch input. Connect a standard momentary footswitch (not included), and you'll be able to defeat the built-in effects and also activate the Master Mute switch. It's an easy way to quickly mute your system for connecting another microphone, swapping out noisy cables, and other situations where you just need to kill all sound momentarily.
Patented Kosmos-C audio enhancement
Peavey equipped the PVi 8500 with their patented Kosmos-C audio enhancement module to make sure your sound is never dull or boring. Peavey explains that Kosmos-C Low control "provides 'natural bass enhancement' by adding harmonically related bass signals that track envelope of the original signal". The High control adds clarity to dull signals. Used together, you can add punch and clarity to any source.
Peavey PVi 8500 8-channel Powered Mixer Features:- Powered mixer with 200W (RMS at 4-ohms) per output channel
- Eight-channel design with ultra-clean Silencer microphone preamplifiers
- Feedback Locating System makes it easy to fight onstage feedback
- 9-band Graphic EQ helps you tune your system to any room
- Mid-Morph EQ makes it fast and easy to dial in a great vocal sound
- Built-in 24-bit effects processing with footswitchable mute
- Kosmos-C audio enhancement module lets you add punch and clarity to dull signals
- Supports SD Card/USB flash drive audio playback
- Bluetooth wireless audio streaming for portable Bluetooth music players
Tech Specs
- Type:Powered
- Channels:8
- Power:2 x 100W RMS @ 4 ohms, 2 x 200W Peak @ 4 ohms
- EQ Bands:3-band EQ (per channel), 9-band Graphic EQ
- Effects:Reverb, Chorus, Delay, Vocal Enhance
- Inputs - Mic Preamps:7 x XLR-1/4" combo, 1 x XLR
- Phantom Power:8 x 15V
- Inputs - Line:7 x XLR-1/4" combo
- Inputs - Other:1 x Dual RCA Stereo (Aux), 1 x 1/8" (Aux)
- Outputs - Main:1 x 14" (main mix), 1 x 1/4" (monitor mix), 2 x 1/4" (speaker out main, main/monitor)
- Outputs - Other:1 x Dual RCA Stereo (record out)
- Aux Sends:1 x Internal FX, 1 x Monitor
- USB:1 x Type A
- Bluetooth:Yes
- Storage:SD card slot
- Height:11.25"
- Width:19.37"
- Depth:10.75"
- Weight:22.2 lbs.
- Manufacturer Part Number:03601860
Subscribe to:
Comments (Atom)